Go Back   The Ford Barn > General Discussion > Early V8 (1932-53)
Reload this Page Thread size for vacuum port on Offy BA 4 barrel-intake under carb mount base?

Sponsored Links (Register now to hide all advertisements)

 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
Old 09-20-2024, 05:48 PM   #3
19Fordy
Senior Member
 
19Fordy's Avatar
 
Join Date: May 2010
Location: Coral Springs FL
Posts: 11,920
Default Re: Thread size for vacuum port on Offy BA 4 barrel-intake under carb mount base?
Anthony; Is the port you are asking about the one in the lower left (1st photo) of this 390 Holley (4160) List 8007 with the rubber cap over it? If so it appears to be pressed in, not threaded. The same is true of the other port for vacuum.
Attached Images
File Type: jpg IMG_3970B.jpg (77.3 KB, 21 views)
File Type: jpg IMG_3974B.jpg (48.1 KB, 16 views)
File Type: jpg IMG_3964B.jpg (73.1 KB, 12 views)
File Type: jpg IMG_3963B.jpg (58.6 KB, 11 views)
Last edited by 19Fordy; 09-20-2024 at 05:59 PM.
19Fordy is offline   Reply With Quote
 

« Previous Thread | Next Thread »
Thread Tools
Display Modes
Threaded Mode Threaded Mode

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts
BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump

Sponsored Links (Register now to hide all advertisements)


All times are GMT -5. The time now is 03:29 AM.