|
|||||||
| Sponsored Links (Register now to hide all advertisements) |
|
|
|
Thread Tools | Display Modes |
07-30-2024, 05:28 AM
|
#5 |
|
Senior Member
Join Date: Aug 2021
Location: IL
Posts: 109
|
Re: piston clearance
Well after you said that I went back and checked and found they are forged steel h beam Rods, so It seems I had a Senior moment LOL Its been two years since I built the motor, not sure where I got the idea they were aluminum, LOL
So to be clear I am looking for .045-.050 total clearance between the piston and head including the head gasket correct? |
|
|
«
Previous Thread
|
Next Thread
»
| Thread Tools | |
| Display Modes | |
Threaded Mode
|
|
| Sponsored Links (Register now to hide all advertisements) |
|
|
All times are GMT -5. The time now is 01:10 AM.