|
|||||||
| Sponsored Links (Register now to hide all advertisements) |
|
|
|
Thread Tools | Display Modes |
05-26-2024, 12:41 PM
|
#7 |
|
Senior Member
Join Date: Jan 2011
Location: Central Ohio
Posts: 5,910
|
Re: Evans Aluminum Heads
The chambers appear to be quite big over the transfer area - so compression will be down as compared to many other heads, but flow will probably be good. In the end, it will probably make no difference. I would use a gasket and blend any sharp edges (in the middle areas) - as they appear to be inside the normal gasket profile.
|
|
|
«
Previous Thread
|
Next Thread
»
| Thread Tools | |
| Display Modes | |
Threaded Mode
|
|
| Sponsored Links (Register now to hide all advertisements) |
|
|
All times are GMT -5. The time now is 04:00 AM.