|
|||||||
| Sponsored Links (Register now to hide all advertisements) |
|
|
 |
|
Thread Tools | Display Modes |
|
|
05-15-2024, 06:54 AM
|
#1 |
|
Senior Member
Join Date: Aug 2018
Location: Ottawa, ON
Posts: 1,378
|
Re: My next flathead build?
So, hot glued a roller bearing to my caliper so I could reach down inside the lower coolant hole to measure the cyl wall thickness. Measured just under 10 mm (9.97 mm), or 0.393”. Not sure if this is a normal wall thickness or not, but folks with more experience should know. Seems kinda thick to me though.
|
|
|
|
«
Previous Thread
|
Next Thread
»
| Thread Tools | |
| Display Modes | |
Hybrid Mode
|
|
| Sponsored Links (Register now to hide all advertisements) |
|
|
All times are GMT -5. The time now is 12:10 PM.