|
|||||||
| Sponsored Links (Register now to hide all advertisements) |
|
|
|
Thread Tools | Display Modes |
12-12-2023, 10:49 AM
|
#5 |
|
Senior Member
Join Date: May 2010
Location: NJ
Posts: 7,233
|
Re: lifter bore adj hole
Depending on the type of cam you are using, I may suggest scalloping the top portion that faces in towards the valley. With a high lift reground cam, the adjusting screw on an adjustable lifter can sometimes sit below the top of the lifter boss which makes it hard to turn the adjusting screw.
Last edited by Tim Ayers; 12-12-2023 at 11:17 AM. |
|
|
«
Previous Thread
|
Next Thread
»
| Thread Tools | |
| Display Modes | |
Threaded Mode
|
|
| Sponsored Links (Register now to hide all advertisements) |
|
|
All times are GMT -5. The time now is 12:45 AM.