The Ford Barn

19Fordy · 08-27-2022, 05:47 PM

sactopv: Read all this:
https://www.google.com/search?q=inst...hrome&ie=UTF-8

You need to use the 1949-51 Merc flywheel, pressure plate and full bell housing with the matching starter plate. You can use the stock 40 throwout bearing. I have an 8BA/8CM in my 40 with the stock 40 transmission. You also need the 49-51 Merc rear sump oil pan or an early Ford pick up rear sump oil pan.
Here's more:
https://www.fordbarn.com/forum/showt...ll+8ba+36+ford
You must read all of this thread.
https://www.fordbarn.com/forum/showt...gine+1940+ford

08-27-2022, 05:47 PM	#4
19Fordy Senior Member Join Date: May 2010 Location: Coral Springs FL Posts: 11,916	Re: 51 Merc into 1940 fordor flywheel clutch questiond sactopv: Read all this: https://www.google.com/search?q=inst...hrome&ie=UTF-8 You need to use the 1949-51 Merc flywheel, pressure plate and full bell housing with the matching starter plate. You can use the stock 40 throwout bearing. I have an 8BA/8CM in my 40 with the stock 40 transmission. You also need the 49-51 Merc rear sump oil pan or an early Ford pick up rear sump oil pan. Here's more: https://www.fordbarn.com/forum/showt...ll+8ba+36+ford You must read all of this thread. https://www.fordbarn.com/forum/showt...gine+1940+ford Last edited by 19Fordy; 08-27-2022 at 05:57 PM.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode