rocker arm oiling problems on Y block

[KULTULZ]

Originally Posted by Gene F

Is that a kit you ordered from somewhere? I thought the issue was the rocker arms? I guess you have to remove the motor to install that setup, due to the shavings when you drill?

How effective is frequent oil changes in lieu of this?

That is fabrication Gene for extreme use, although if I were to build a nice street engine, it would have it.

It by-passes all the Mickey Mouse engineering on oil supply to the heads found on the Y-BLOCK. It can also be done the old fashioned way.

A high detergent oil is needed on one of these if no PCV SYSTEM is installed especially (IMO).