|
|||||||
| Sponsored Links (Register now to hide all advertisements) |
|
|
|
Thread Tools | Display Modes |
07-09-2021, 09:59 AM
|
#18 |
|
Senior Member
Join Date: Jun 2015
Location: Red Deer, Alberta
Posts: 6,077
|
Re: crank pulley removal
Ifn the "second part" is cast iron you may be able to crack it in 2 w/a good bucking bar under it and a chisel on top. A blunt chisel may be better than a sharp one, to prevent damaging the crankshaft.
__________________
If you don't hear a rumor by 10 AM, start one!. Got my education out behind the barn! |
|
|
«
Previous Thread
|
Next Thread
»
| Thread Tools | |
| Display Modes | |
Threaded Mode
|
|
| Sponsored Links (Register now to hide all advertisements) |
|
|
All times are GMT -5. The time now is 07:05 PM.