|
|||||||
| Sponsored Links (Register now to hide all advertisements) |
|
|
|
Thread Tools | Display Modes |
02-09-2020, 01:06 PM
|
#8 |
|
Senior Member
Join Date: May 2010
Location: Portland OR
Posts: 6,458
|
Re: Hub seal orientation
I put mine on so any part that slides into or onto you don't have to fight the taper in the seal so the open side is to the grease not away. When grease is added, you want the lip to be pushed to seal, not pushed to open and allow the grease past.
__________________
I know the voices aren't real but damn they have some good ideas! 
|
|
|
«
Previous Thread
|
Next Thread
»
| Thread Tools | |
| Display Modes | |
Threaded Mode
|
|
| Sponsored Links (Register now to hide all advertisements) |
|
|
All times are GMT -5. The time now is 06:43 AM.