Go Back   The Ford Barn > General Discussion > Early V8 (1932-53)
Reload this Page 8BA Edelbrock head clearance

Sponsored Links (Register now to hide all advertisements)

 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
Old 09-24-2019, 09:15 AM   #9
61Klassic
Member
 
Join Date: Jul 2019
Location: Kent UK
Posts: 35
Default Re: 8BA Edelbrock head clearance
OK, so with the material in the head over the piston, has anyone tried using 4" pistons on a 4.125" crank and machining the head .125" and blending into the valve relief.
In theory this would allow compression to be kept high while allowing good flow up high in the chamber as opposed to relieving?
61Klassic is offline   Reply With Quote
 

« Previous Thread | Next Thread »
Thread Tools
Display Modes
Threaded Mode Threaded Mode

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts
BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump

Sponsored Links (Register now to hide all advertisements)


All times are GMT -5. The time now is 07:09 PM.