babbit tolerance? .000? - The Ford Barn

		The Ford Barn > General Discussion > Model A (1928-31)
babbit tolerance? .000?

Sponsored Links (Register now to hide all advertisements)

Prev

Previous Post

Next Post

Next

09-11-2019, 11:27 AM	#11
Jim Brierley Senior Member Join Date: Jun 2010 Location: Temecula, CA Posts: 4,321	Re: babbit tolerance? .000? I set all mains at .0025" on my inserted race engines, with a groove to feed the rear at 2 different spots. First I ever heard Patrick L's story about extra clearance helping rear flange breakage!

« Previous Thread | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Forum Rules

Sponsored Links (Register now to hide all advertisements)

All times are GMT -5. The time now is 01:01 AM.