|
|||||||
| Sponsored Links (Register now to hide all advertisements) |
|
|
|
Thread Tools | Display Modes |
08-04-2019, 10:16 AM
|
#5 |
|
Senior Member
Join Date: May 2010
Location: Kerrville, Tx
Posts: 2,919
|
Re: Need to replace headgasket
Tubman, !!!!! CORRECT!!!!
I thought my engine would never give up the heads put on with copper coat.I had to drive wedges in all around the heads. I was sure I was going to crack the block or warp the heads. The gaskets were so solidly adhered that they had to seperate down the middle. |
|
|
«
Previous Thread
|
Next Thread
»
| Thread Tools | |
| Display Modes | |
Threaded Mode
|
|
| Sponsored Links (Register now to hide all advertisements) |
|
|
All times are GMT -5. The time now is 01:20 AM.