|
|||||||
| Sponsored Links (Register now to hide all advertisements) |
|
|
|
Thread Tools | Display Modes |
04-29-2019, 11:02 AM
|
#11 |
|
Senior Member
Join Date: May 2010
Location: Long Island, NY
Posts: 1,052
|
Re: First Flathead Build
Hi "sharp", try to find a shop who will use a block-plate to finish-hone the bores, it's fairly important on these Flathead castings!
Also, make certain you have it pressure-tested, do not rely on "magging" only! Thanks, Gary in N.Y. P.S. Would also strongly recommend some stainless valves and some bronze-lined guides so there will be no valves "hanging" down the road.
__________________
http://www.stromberg-bulletin.com/me...berg-equipped/ |
|
|
«
Previous Thread
|
Next Thread
»
| Thread Tools | |
| Display Modes | |
Threaded Mode
|
|
| Sponsored Links (Register now to hide all advertisements) |
|
|
All times are GMT -5. The time now is 12:50 AM.