The Ford Barn

rustynut4247 · 01-18-2018, 02:40 PM

Chris
Hi, I am about to finish my 1947 COE. As far as the wiring goes it is made by Bauer MFG. in Oregon. The bearings are standardized. If you can get the number off the bearing and manufacturer, there is a place you can try called Detroit Ball Bearing.
I have used him for years and they have always had what I needed. I also think they do oil seals too.
I use to make sheet metal parts for the COE's before I retired.
Any questions give me a call at 248-853-4027. I am in Michigan
Thanks Todd

01-18-2018, 02:40 PM	#20
rustynut4247 Senior Member Join Date: May 2017 Location: rochester hills mich Posts: 124	Re: '41 Ford COE questions Chris Hi, I am about to finish my 1947 COE. As far as the wiring goes it is made by Bauer MFG. in Oregon. The bearings are standardized. If you can get the number off the bearing and manufacturer, there is a place you can try called Detroit Ball Bearing. I have used him for years and they have always had what I needed. I also think they do oil seals too. I use to make sheet metal parts for the COE's before I retired. Any questions give me a call at 248-853-4027. I am in Michigan Thanks Todd

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode