06-20-2017, 10:34 PM
|
#27 |
|
Senior Member
Join Date: May 2017
Location: Arkansas
Posts: 768
|
Re: 8BA Lifters?
So I looked at my adjustable lifters today, the 8 I have out of the block. They are hollow, with three oblong diagonal slots on each. They look good. But, they are dead flat on the bottom.....nice and polished. Straight edge shows them dead flat, set them on my heavy saw table they don't rock at all.
And this is NOT good, correct? And I might needs be making other plans for lifters? Thanks to all you not tired of advising me about my lifters! |
|
|
«
Previous Thread
|
Next Thread
»
| Thread Tools | |
| Display Modes | |
Threaded Mode
|
|
| Sponsored Links (Register now to hide all advertisements) |
|
|
All times are GMT -5. The time now is 05:41 AM.