The Ford Barn

Canuk40 · 05-09-2017, 10:03 AM

Randy - You are the man. I looked at Drake's site and couldn't find it. Thanks.
TJ - I am doing as you suggest. I have the reinforcement of the B pillars mostly figured out. Very busy place - floor, rocker, rocker extension, B pillar and rear fender tab all come together and attach with 1 bolt. Won't tack it together until I test fit the doors.
As for A pillar, I am replacing both left and right cowl sections with parts from Dennis Carpenter. Promises to be an education in fabrication and fitment.
Once I have all put together and doors back on for fitting, I will detach the completed body and swap frames.
Any additional input of suggestions always welcome.

05-09-2017, 10:03 AM	#5
Canuk40 Junior Member Join Date: Feb 2015 Location: Rosseau. Ontario Posts: 16	Re: How many attachment points in a 1940 Ford Tudor Randy - You are the man. I looked at Drake's site and couldn't find it. Thanks. TJ - I am doing as you suggest. I have the reinforcement of the B pillars mostly figured out. Very busy place - floor, rocker, rocker extension, B pillar and rear fender tab all come together and attach with 1 bolt. Won't tack it together until I test fit the doors. As for A pillar, I am replacing both left and right cowl sections with parts from Dennis Carpenter. Promises to be an education in fabrication and fitment. Once I have all put together and doors back on for fitting, I will detach the completed body and swap frames. Any additional input of suggestions always welcome.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode