Conversion of Banjo Rear Axle to Modern Axles

[rotorwrench]

The Hot Rod Works is in Caldwell, Idaho.

[JSeery]

Originally Posted by rotorwrench

The Hot Rod Works is in Caldwell, Idaho.

I have spoken with them, but this gentleman was retired and may have been a different source (or maybe not). I just can't remember, but he was very helpful.

A fellow going by Modernbeat posted a transcription of the Hot Rod Nov 1960 article back in 2003 if anyone is interested: http://www.jalopyjournal.com/forum/t...ux-w-pics.151/

Good Rod & Custom article on HRW conversion: http://www.hotrod.com/articles/1112r...banjo-rearend/

[hardtimes]

Originally Posted by JSeery

I have spoken with them, but this gentleman was retired and may have been a different source (or maybe not). I just can't remember, but he was very helpful.

A fellow going by Modernbeat posted a transcription of the Hot Rod Nov 1960 article back in 2003 if anyone is interested: http://www.jalopyjournal.com/forum/t...ux-w-pics.151/

Good Rod & Custom article on HRW conversion: http://www.hotrod.com/articles/1112r...banjo-rearend/

Hey JSeery, Good Stuff, indeed !
Thanks again for your sharing/input to this subject.
I started reading/studying first old referenced article above. Now, I'm no computer nerd, and can not get any pictures to show/open from the old article. Keeps sending to to HAMB when I click on picture. Any help