Go Back   The Ford Barn > General Discussion > Early V8 (1932-53)
Reload this Page Retro fitting an 8BA crankshaft into my 42 block?

Sponsored Links (Register now to hide all advertisements)

Reply
 
Thread Tools Display Modes
Old 01-24-2017, 03:40 AM   #1
ford1933-2008
Senior Member
 
Join Date: Mar 2011
Location: Australia
Posts: 167
Default Re: Retro fitting an 8BA crankshaft into my 42 block?
Gentlemen,

Thank you very much for your kind advice, much appreciated. I am using a stock 8BA crankshaft, 42 main bearings, 8BA rods and bearings. I am now just waiting on the rear aluminum seal retainer before I assemble.

Thanks again this is such a great forum.
ford1933-2008 is offline   Reply With Quote
Reply

« Previous Thread | Next Thread »
Thread Tools
Display Modes
Hybrid Mode Hybrid Mode

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts
BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump

Sponsored Links (Register now to hide all advertisements)


All times are GMT -5. The time now is 08:19 PM.