|
|||||||
| Sponsored Links (Register now to hide all advertisements) |
|
|
|
Thread Tools | Display Modes |
06-29-2016, 11:13 PM
|
#4 |
|
Senior Member
Join Date: May 2010
Location: Mpls, MN
Posts: 27,582
|
Re: Greasing spindles
Might try a heat gun to get the bushings fairly hot. I'm using a well worn temporary axle on my 28 while I restore the original, and it also has a couple fittings that won't take grease.
You might be able to find a special grease tool that you strike with a hammer to knock the grease into the fitting. I should have bought the one I saw years ago. |
|
|
«
Previous Thread
|
Next Thread
»
| Thread Tools | |
| Display Modes | |
Threaded Mode
|
|
| Sponsored Links (Register now to hide all advertisements) |
|
|
All times are GMT -5. The time now is 07:57 AM.