Cowl Stainless Steel Band Installation

[Big hammer]

Cowl band stud should be at a 30 degree angle to the band, near the cowl bottom there should be a slot for the stud, inside cowl there should be a boss at a angle for the stud. Get one side one first then back off nut to the end of the stud, then work on the other side. Studs can be short if body work has been done ( poorly )

[billyboy]

Originally Posted by Big hammer

Cowl band stud should be at a 30 degree angle to the band, near the cowl bottom there should be a slot for the stud, inside cowl there should be a boss at a angle for the stud. Get one side one first then back off nut to the end of the stud, then work on the other side. Studs can be short if body work has been done ( poorly )

I have no slot visible from exterior for the band stud to enter. Will try locate boss on inside after car comes back from paint shop.
Thanks for information.