Go Back   The Ford Barn > General Discussion > Early V8 (1932-53)
Reload this Page thread chaser kit

Sponsored Links (Register now to hide all advertisements)

 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
Old 05-20-2010, 10:25 AM   #11
Andy
Senior Member
 
Join Date: May 2010
Location: Kerrville, Tx
Posts: 2,919
Default Re: thread chaser kit
The threads for the heads in a flathead are not standard tolerance. I would use a old stud with a thread cutting groove. I bevel the end to make a simple cutting edge.
Andy is offline   Reply With Quote
 

« Previous Thread | Next Thread »
Thread Tools
Display Modes
Threaded Mode Threaded Mode

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts
BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump

Sponsored Links (Register now to hide all advertisements)


All times are GMT -5. The time now is 06:03 AM.