Go Back   The Ford Barn > General Discussion > Early V8 (1932-53)
Reload this Page Kit for mating juice brakes to early spindles-Richard's Early V8 garage?

Sponsored Links (Register now to hide all advertisements)

 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
Old 03-02-2015, 02:34 PM   #22
Tim Ayers
Senior Member
 
Join Date: May 2010
Location: NJ
Posts: 7,233
Default Re: Kit for mating juice brakes to early spindles-Richard's Early V8 garage?
Quote:
Originally Posted by FlatheadTed View Post
this is 34 to 39-40
I thought about doing this as well. My concern was messing up a set of '32 spindles by generating too much heat from the MIG. If I had a TIG, I would go this route.

Maybe my concern is unfounded, but love to hear from others who added width to the spindle sides v. modifying the backing plate.
Tim Ayers is offline   Reply With Quote
Sponsored Links (Register now to hide all advertisements)
 

« Previous Thread | Next Thread »
Thread Tools
Display Modes
Threaded Mode Threaded Mode

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts
BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump

Sponsored Links (Register now to hide all advertisements)


All times are GMT -5. The time now is 01:42 AM.