|
|||||||
| Sponsored Links (Register now to hide all advertisements) |
|
|
|
Thread Tools | Display Modes |
08-17-2014, 04:09 PM
|
#23 |
|
Senior Member
Join Date: Sep 2013
Posts: 1,027
|
Re: adjusting 3 / 2's
Martin, I am adjusting the two screws on the front base of the carb. I start the engine, turn the idle screw up to get some rpm's then adjust these two screws. I turn each one in until the engine begins to run rough, then back off until engine runs smooth. But these aren't the right ones? AAAARRRRGGGHHHHHH!!!!
|
|
|
«
Previous Thread
|
Next Thread
»
Threaded Mode
|
|
| Sponsored Links (Register now to hide all advertisements) |
|
|
All times are GMT -5. The time now is 01:01 AM.