Go Back   The Ford Barn > General Discussion > Model A (1928-31)

Sponsored Links (Register now to hide all advertisements)

 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
Old 08-13-2010, 04:42 PM   #1
Bobster
Member
 
Bobster's Avatar
 
Join Date: May 2010
Location: Huntington, WV
Posts: 52
Default Radiator temps

Hey - It has been hot in WV this past two months - temps in high 90's most days. Went to Harbor Freight and bought a non contact thermometer to check radiator temps after a run. I register 180 degrees when I shut off the engine after a five mile circuit - temps rise to 200-206 after shutoff - no boil over. The radiator was "flow tested" at a local shop and declared good. I run 50/50 mix water/antifreeze with no water wetter or any other additive. Motor runs fine, but is the running temp too high? Should I flush out the radiator - engine? I do not think the engine was flushed before I bought the car. There is a lot of heat felt through the floorboards. At 35 mph it subsides some. Thanks, BW
__________________
BW in WV
Bobster is offline   Reply With Quote
 


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Sponsored Links (Register now to hide all advertisements)


All times are GMT -5. The time now is 03:03 PM.