|
|||||||
| Sponsored Links (Register now to hide all advertisements) |
|
|
|
Thread Tools | Display Modes |
10-27-2024, 08:04 PM
|
#1 |
|
Senior Member
Join Date: May 2010
Location: Michigan
Posts: 583
|
Head gasket opinion please.
Just putting my 8-BA back together and was wondering about copper head gaskets and Aluminum heads. I am concerned with electrolysis between the two different metals. Also having a hard time finding big bore gaskets. I'm 3-3/8"X 4-1/16 or 396 CI"s. Seems everyone is out of copper but will go with Felpro and copper spray if necessary. Thanks in advance for your opinions. As a side note. I'm running a Potvin Cam that is stamped 410. Can't find any info on it so I am assuming that is the lift.
|
|
|
«
Previous Thread
|
Next Thread
»
Threaded Mode
|
|
| Sponsored Links (Register now to hide all advertisements) |
|
|
All times are GMT -5. The time now is 01:14 PM.