|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
02-10-2023, 05:50 PM | #1 |
Member
Join Date: Jun 2011
Location: Norwalk,Iowa
Posts: 50
|
Intake questions
I took this intake off my engine because the flanges that position the generator bracket are broken. My question is about the two ports seen in the photo. I think I know what one of them is for, but rather than show my ignorance. I am asking for your input. While I am asking questions about the intake, a local flathead builder is a firm believer in using a phenolic (?) spacer between the intake and carburetor. So where is a good place to get one? Thanks, Bergie.
|
|
|
Sponsored Links (Register now to hide all advertisements) |
|