06-17-2017, 09:37 PM
|
#1 |
|
Senior Member
Join Date: May 2017
Location: Arkansas
Posts: 768
|
8BA Lifters?
A quick question. I'm reading back pages, learning as much as I can. Today I got one complete valve/guide assembly out, so I know how to do the others. This seems like a good engine, but crusty as you know what.
So, the lifter? Is it supposed to just pull up out of it's hole? Circlip or anything holding it? Still too dirty in there to see well. Tried searching, every relevant post mentions valve/guide/spring, etc., but not the lifter. Thanks!! |
|
|
«
Previous Thread
|
Next Thread
»
Threaded Mode
|
|
| Sponsored Links (Register now to hide all advertisements) |
|
|
All times are GMT -5. The time now is 09:29 PM.