|
|||||||
| Sponsored Links (Register now to hide all advertisements) |
|
|
|
Thread Tools | Display Modes |
03-07-2017, 11:22 AM
|
#1 |
|
Senior Member
Join Date: Jan 2014
Location: Orcas Island Washington
Posts: 6,202
|
Removing broken head bolt
On my recently acquired 59 ab the head was on with 8BA head bolts. PO broke one off flush on a lower corner. Can I safely weld a washer, then a nut to that for removal? Just not sure if localizing that much heat is ok on the cast iron. I did a search but didn't find anything. Thanks
__________________
Owner/Operator of 'Jailbar Ranch' on the side of Mt. Pickett. Current stable consists of 1946 1/2 ton pickup turned woodie wagon with FH V8, 1946 Tonner Pickup with 226 H six, 1979 Toyota landcruiser wagon, now wearing 1947 Ford Jailbar sheet metal. 'Rusty ol' floorboards, hot on their feet' (Alan Jackson) |
|
|
«
Previous Thread
|
Next Thread
»
Threaded Mode
|
|
| Sponsored Links (Register now to hide all advertisements) |
|
|
All times are GMT -5. The time now is 09:12 AM.