The Ford Barn

Teich · 01-11-2011, 07:16 PM

I used the full flow system described by JM 35 Sedan in a Canadian block allready had two vertical holes, just drilled and taped 3/8 pipe to plug the cross over 7/16"NF socket head set screw works as the will accept 7/16 tap. My system is 100% filtered a i drilled a hole from rear cam bearing down to the rear main, used the same size as the other oil passages, removed the fuel pump pushrod bushing and pluged hole. Put a peice of 1/4" fod into orig. oil passage from pump to the bearing. Useing a Ford spin on filter NAPA the best least pres. drop. Works very good about 6500 miles idles at 10 hot 10/30 or 20/50. Laurie

01-11-2011, 07:16 PM	#11
Teich Senior Member Join Date: May 2010 Location: Brandon Mb Canada Posts: 133	Re: Flathead filter I used the full flow system described by JM 35 Sedan in a Canadian block allready had two vertical holes, just drilled and taped 3/8 pipe to plug the cross over 7/16"NF socket head set screw works as the will accept 7/16 tap. My system is 100% filtered a i drilled a hole from rear cam bearing down to the rear main, used the same size as the other oil passages, removed the fuel pump pushrod bushing and pluged hole. Put a peice of 1/4" fod into orig. oil passage from pump to the bearing. Useing a Ford spin on filter NAPA the best least pres. drop. Works very good about 6500 miles idles at 10 hot 10/30 or 20/50. Laurie