Rear axle housing repair : my feeback

[tof33]

Hello
Recently I bought a Ford 35 and during a rear brake inspection I showed the wheel bearing surface of the axle housings was scored on the under side between 0.02 to 0.11".
Usually you have to buy a new inner race and grind the shaft housing : quite hard, expensive and who can do that ??

So I think to an other method. Only 100 miles since but all is OK

I put a big IKO bearing on the hub (no grinding needed): ref: TR628138-IKO
I insert the bearing inner ring (LRT556238.5-IKO) with an other custom made inner ring and a lot of Loctite 638.

See pictures...

Regards