|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
05-01-2016, 12:46 PM | #1 |
Member
Join Date: Jun 2010
Posts: 73
|
1935 horn wiring problems
Ok I am trying to get two new horns wired up on a 1935 restoration. The wiring harness has 6V to ground on the two yellow wires on each side. On the Blue Yellow wire I get a short to ground when the horn button is depressed and a break when it is released on both sides.
This Seems correct to me at this point, so this is where the fun begins. I have two new 6v horns from Dennis Carpenter or some other vender. I have taken them apart to see which terminal is ground and which goes through the electro magnet. If I check both the terminals they short to each other and to ground (not sure if that is correct). When I hook up the right horn it works correctly (it works with the horn button) but I get 6v to ground on both wires on the left. and can't hook the other horn up. Any thoughts anyone. Could the problem be in the horns themselves? thanks |
|
|
Sponsored Links (Register now to hide all advertisements) |
|