The Ford Barn

nick c · 08-26-2010, 02:38 PM

Could someone please explain to me the correct way to install door glass in my door. I dont believe it will go through the hole in the bottom, so it must go in the top. I bought the expensive felt channel kit from Mikes. I need to know the proper procedure to install the felt channel and the glass.
thanks nick

JTW · 08-26-2010, 05:22 PM

The trim, around window on the inside of the door, slides up and off as a unit. Put the fluid to it as sometimes they are rusted on - tap lightly with a mallet and block of soft wood. You then should have the room that you need.

Steve from PA · 08-27-2010, 05:45 AM

After you remove the frame with rthe glass 3/4 of the way up the glass and the felt tracks will be able to be tilted in enough so the glass slides up and out.

nick c · 08-27-2010, 06:50 AM

Sponsored Links (Register now to hide all advertisements)

At the top of the door where the foam rubber gets glued on, there is no metal in the corners to glue to, is there supposed to be a piece of channel that goes across and covers the open corners?

08-26-2010, 02:38 PM	#1
nick c Senior Member Join Date: Aug 2010 Posts: 260	29 cc pu door glass Could someone please explain to me the correct way to install door glass in my door. I dont believe it will go through the hole in the bottom, so it must go in the top. I bought the expensive felt channel kit from Mikes. I need to know the proper procedure to install the felt channel and the glass. thanks nick

08-26-2010, 05:22 PM	#2
JTW Senior Member Join Date: May 2010 Location: Owls Head Posts: 257	Re: 29 cc pu door glass The trim, around window on the inside of the door, slides up and off as a unit. Put the fluid to it as sometimes they are rusted on - tap lightly with a mallet and block of soft wood. You then should have the room that you need.

08-27-2010, 05:45 AM	#3
Steve from PA Junior Member Join Date: May 2010 Posts: 4	Re: 29 cc pu door glass After you remove the frame with rthe glass 3/4 of the way up the glass and the felt tracks will be able to be tilted in enough so the glass slides up and out.

08-27-2010, 06:50 AM	#4
nick c Senior Member Join Date: Aug 2010 Posts: 260	Re: 29 cc pu door glass Sponsored Links (Register now to hide all advertisements) At the top of the door where the foam rubber gets glued on, there is no metal in the corners to glue to, is there supposed to be a piece of channel that goes across and covers the open corners?