03-11-2012, 05:17 AM | #1 |
Senior Member
Join Date: Aug 2010
Location: Geelong Australia
Posts: 119
|
Universal fit
Just checking on fitment of the uni to the trans.output shaft ,i have a small amount of movement on the spline side to side ,the uni would be more likely to wear i would think ,this is without the bolt in position,do new unis have movement ,,thanks ,,Rod,,
|
03-11-2012, 10:05 AM | #2 |
Senior Member
Join Date: May 2010
Location: on the Littlefield
Posts: 6,181
|
Re: Universal fit
Is this "small" movement barely perceptable, or can you see it flop around--??
If it is barely perceptable it is probably in the range of normal, the thick washer (don't forget to have the tang drop into a spline) and bolt clamp the assembly together. The U-joint cross needs to slide side to side a good distance, but should have barely perceptable rotational play. |
Sponsored Links (Register now to hide all advertisements) |
|
03-11-2012, 11:51 PM | #3 |
Senior Member
Join Date: Nov 2011
Location: B.C. Canada
Posts: 1,746
|
Re: Universal fit
Both ends of the U-joint should have a nice slip fit on the splines-any more & it will be working on the splines & may loosen the thick washer over time.
|
03-12-2012, 03:39 PM | #4 |
Senior Member
Join Date: Aug 2010
Location: Geelong Australia
Posts: 119
|
Re: Universal fit
Sponsored Links (Register now to hide all advertisements)
|
|
|
Sponsored Links (Register now to hide all advertisements) |
|