|
Sponsored Links (Register now to hide all advertisements) |
|
![]() |
![]() |
Thread Tools | Display Modes |
![]() |
#1 |
Senior Member
Join Date: May 2010
Location: Gwynn's Island Va
Posts: 1,604
|
![]()
Im installing a new top on my 30ccpu. Im replacing all the wood also.
On the rear headder what should I use for anti-squeek? Friction tape? other ideas? For sealing the top should I just use a rtv sealant from the local autoparts store? Thanks Wick |
![]() |
![]() |
![]() |
#2 |
Senior Member
Join Date: Jan 2011
Location: Opelika,Al.
Posts: 132
|
![]()
For the sealing I plan to use Sikaflex 1A, I couldn't find it locally but googled the name and purchased two tubes from a place called collagetoolbox. Hope this helps.
|
![]() |
![]() |
Sponsored Links (Register now to hide all advertisements) |
|
![]() |
#3 |
Senior Member
Join Date: May 2010
Location: Quincy CA
Posts: 752
|
![]()
Frequent poster Jim Boehmke always recommends PL Polyurethane Roof & Flashing Sealant.
Haven't seen him on here for a while, so I'll do it for him. Joe
__________________
1929 Tudor since 1962 Feather River A's |
![]() |
![]() |
![]() |
#4 |
Senior Member
Join Date: Jan 2011
Location: Opelika,Al.
Posts: 132
|
![]() Sponsored Links (Register now to hide all advertisements)
|
![]() |
![]() |
![]() |
|
|
Sponsored Links (Register now to hide all advertisements) |
|