|
|||||||
| Sponsored Links (Register now to hide all advertisements) |
|
|
 |
|
Thread Tools | Display Modes |
09-24-2013, 03:28 PM
|
#1 |
|
Senior Member
Join Date: Jul 2013
Location: San Antonio, Texas
Posts: 687
|
Valve guide question
When installing valve guides, should smear assembly lube inside the guide for the valve before I install it ?
|
|
|
|
09-24-2013, 03:29 PM
|
#2 |
|
Senior Member
Join Date: Jul 2013
Location: San Antonio, Texas
Posts: 687
|
Re: Valve guide question
The red book doesn't say to do so but I just want to make sure.
|
|
|
|
| Sponsored Links (Register now to hide all advertisements) |
|
|
|
09-24-2013, 03:30 PM
|
#3 | |
|
Senior Member
Join Date: May 2010
Location: Eastern Tennessee
Posts: 11,972
|
Re: Valve guide question
Quote:
Doesn't hurt. Just curious, are these one-piece or two piece that you are installing? |
|
|
|
|
)|
09-24-2013, 03:33 PM
|
#4 |
|
BANNED
Join Date: May 2010
Location: Bucks County, PA
Posts: 11,454
|
Re: Valve guide question
LUBE is your friend
|
|
|
|
|
09-24-2013, 03:43 PM
|
#5 |
|
Senior Member
Join Date: May 2010
Location: Mpls, MN
Posts: 27,582
|
Re: Valve guide question
I lube every moving part, which reminds me, it's been a few months since I oiled the distributor cup.
I'd also lube the outside of the guides to make them slide into place easier. |
|
|
|
|
09-24-2013, 09:30 PM
|
#6 |
|
Senior Member
Join Date: Jul 2013
Location: San Antonio, Texas
Posts: 687
|
Re: Valve guide question
Sponsored Links (Register now to hide all advertisements)
|
|
|
|
|
«
Previous Thread
|
Next Thread
»
Linear Mode
|
|
| Sponsored Links (Register now to hide all advertisements) |
|
|
All times are GMT -5. The time now is 06:27 AM.