The Ford Barn - View Single Post

Deadforty · 06-05-2021, 05:40 PM

Well, I finally got the "40 running again !! Now, I'm trying to tie up loose ends. How do you check to see whether or not your gauges are not working? I did the CVR route and only the Temp and Volt gauge is working. I mistakenly installed a 80lb oil pressure sender, using a 40lb pump. Can this be remedied by changing senders? Also, I might add that the gas and oil pressure were registering, but suddenly quit while driving down the road. I don't know what to check or do at this point.
P.S.
This site has been a great source of information in this rebuild! A lot of good people with similar interests !!!!

06-05-2021, 05:40 PM	#1
Deadforty Junior Member Join Date: Jul 2019 Posts: 18	'40 Gas, Oil pressure Gauges Well, I finally got the "40 running again !! Now, I'm trying to tie up loose ends. How do you check to see whether or not your gauges are not working? I did the CVR route and only the Temp and Volt gauge is working. I mistakenly installed a 80lb oil pressure sender, using a 40lb pump. Can this be remedied by changing senders? Also, I might add that the gas and oil pressure were registering, but suddenly quit while driving down the road. I don't know what to check or do at this point. P.S. This site has been a great source of information in this rebuild! A lot of good people with similar interests !!!!