Sponsored Links (Register now to hide all advertisements)
To start I hope everyone had a great holiday with their families and that 2017 is starting off well.
I found a great set of rear radius rods in the classified section of the barn. Thanks Lloyd. Going to get them sanded down and painted before installing, but I'll have to wait for temps to get a little warmer for the paint part.
So I went back to troubleshooting my starter problem/rebuild. I was finally able to remove the field coils. I went over to a buddies shop and he got out his torches. Got the screws nice and red and they backed right out. I sandblasted the case and have it in primer now, again waiting on a warm day to paint.
When I went to solder on the brushes I noticed that the coils were pre bent, and both sets done the same way. Are these easy to re-curve the opposite direction? Any tips on how to do this without causing damage?
Sent from my iPhone using Tapatalk