Thread
:
Checking bottom end bearing clearances
View Single Post
09-18-2017, 06:04 PM
#
10
BILL WILLIAMSON
Senior Member
Join Date: Dec 2010
Location: FRESNO, CA
Posts: 12,560
Re: Checking bottom end bearing clearances
Chief used little squares of shim stock & nipped the corners, so as NOT to scratch the Babbitt.
Bill Oilintheface
__________________
"THE ASSISTANT GURU OF STUFF"
BILL WILLIAMSON
View Public Profile
Send a private message to BILL WILLIAMSON
Find More Posts by BILL WILLIAMSON