The Ford Barn - View Single Post

100IH · 06-20-2019, 03:27 PM

Any crud getting loose doing the head would all be above the rings. Not going to go past the rings and into the pan. At least not until running quite a while and compromising said rings and cylinder walls. OHV not so much, the oil does run back into the pan from the valvecover.

06-20-2019, 03:27 PM	#13
100IH Senior Member Join Date: Dec 2011 Location: SW Idaho Posts: 970	Re: Oil change after head gasket job? Any crud getting loose doing the head would all be above the rings. Not going to go past the rings and into the pan. At least not until running quite a while and compromising said rings and cylinder walls. OHV not so much, the oil does run back into the pan from the valvecover.