Thread
:
Checking bottom end bearing clearances
View Single Post
09-19-2017, 08:58 AM
#
15
Tom Wesenberg
Senior Member
Join Date: May 2010
Location: Mpls, MN
Posts: 27,582
Re: Checking bottom end bearing clearances
Quote:
Originally Posted by
BILL WILLIAMSON
And some say, "OH, while you got the pan off, check the clearance on the MAINS"---As if it's a 20 Minute Picnic
--IT'S A BITCH OF A JOB--NLOL
Bill Oily
Yep, it is a job. How about using a dial indicator and move the crank up and down to measure the clearance? The bad thing is you won't get to see the condition of the babbit.
Tom Wesenberg
View Public Profile
Send a private message to Tom Wesenberg
Find More Posts by Tom Wesenberg