Re: The Terry Burtz 5 main bearing engine blocks are back on track.
I am going to hop one up a bit.
I have a modified Roof head ready to go on the one I have on order. About two years ago, on a B block, it put out 118 hp at 3500 rpm but was underperforming between 1800 - 2600 rpm.
I don't run my engine up to 3500 rpm so I advanced the cam timing 4 degrees to increase lower end torque. The maximum hp was now 88 at 2800 - 3000 rpm and the torque was almost doubled from 1800 to 2600 rpm.
I am not sure how I will set/degree the cam on the new block yet...
Good Day!
Last edited by Dave in MN; 02-04-2021 at 06:54 PM.
|