Quote:
Originally Posted by katy
I assume that you meant regulator, not rectifier?
|
I meant rectifier. Here is a link to a kit on flea-pay.
https://www.ebay.com/itm/10SI-Delco-...6606664?_ul=IN
The kit includes the regulator and brush holder stack with special hardware and the rectifier bridge block. All of this stuff makes for a positive ground polarity, 6-volt alternator. There are even U-tube instructions for these conversions.
It's one way to freshen up an older unit as well since it comes with bearings too.
The best way to use a 10/12si type alternator is as it was originally intended. That is 12-volt 3-wire system but most folks don't want to go 12-volt or negative ground.