The Ford Barn - View Single Post

MVal · 06-10-2016, 01:37 PM

I am replacing the brushes and cleaning up an original 6 volt long style generator with a bearing in front and a bushing at the rear. My question is how is the steel washer removed that is holding the bearing in place on the shaft? Bratton's catalog lists it as a bearing retainer ring I believe but mine is not split as shown on their drawing.

06-10-2016, 01:37 PM	#1
MVal Member Join Date: May 2010 Posts: 69	Generator bearing replacement I am replacing the brushes and cleaning up an original 6 volt long style generator with a bearing in front and a bushing at the rear. My question is how is the steel washer removed that is holding the bearing in place on the shaft? Bratton's catalog lists it as a bearing retainer ring I believe but mine is not split as shown on their drawing.