The Ford Barn - View Single Post

Reelnative · 07-14-2020, 10:59 AM

I checked it and it is straight, I don't think I over torqued them, maybe not tight enough. I will make one tonight from 1/32 material and re-torque them after running a while.

Thanks

07-14-2020, 10:59 AM	#4
Reelnative Junior Member Join Date: May 2020 Location: Melbourne, FL Posts: 28	Re: Carburetor base gasket I checked it and it is straight, I don't think I over torqued them, maybe not tight enough. I will make one tonight from 1/32 material and re-torque them after running a while. Thanks