[Ken Henry]

Thanks Glenn! I ordered a 12" aluminum air cleaner from ebay and an extra top. For the base, I bored two holes in the correct position for the two throttle bodies. You should be able to see some hex standoffs at the top of the throttle bodies on some of the pictures. These are for securing the base down to the throttle bodies, which is done with the velocity stacks removed since the openings in the air cleaner base are smaller than the tops of the velocity stacks. Then the velocity stack pop in along with seals where they pass through the air cleaner. I'll try to post a picture later. I might go to a taller air cleaner since I have plenty of room under the hood... Ken