[sugarmaker]

Thanks for the heads up on this bolt issue. One was already broke off when I got it. And I did break a bolt in a tractor flywheel one time too. I will try to watch this hole depth.

I did plasti-gage all the rods and caps from both engines,on the #2 engine crank. They all have a fair amount of babbit remaining. with the rods from #1 engine having about .0015 to .002 clearance and the # 2 engine rods which were on this crank had about .003 clearance. So I guess either set of rods might work If this #2 engine would get assembled.

Worked on wood most of the day, going up the right side of the stairwell.

Happy Labor Day!
Regards,
Chris