Quote:
Originally Posted by Graham Freeman
I stripped the shielding off the portion that is on the top of the bow (staples should not be a problem as staples are only into wood and will not earth out).
I retained shielding around where the wire comes onto the bow to prevent this.
I drilled a small hole through the end of the bow to feed the wire onto the bow and also so it could be fixed hidden behind the top iron.
I will feed the wire along inside sill and up behind cowl panel to radio.
Hope it all works out.
Being in the lower part of New Zealand the top might not go up and down too often.
|
Just a thought,
You might want to put a connection for the antenna wire on your top bow. That way if the shielded wire breaks from putting the top up and down, you can replace it. Otherwise you have to remove the top to replace the antenna.
Good luck!
Sent from my iPad using Tapatalk