View Single Post
Old 07-23-2020, 08:34 AM   #9
ryanheacox
Senior Member
 
ryanheacox's Avatar
 
Join Date: Apr 2013
Location: Northwest CT
Posts: 1,028
Default Re: Pressure plate adjustment

Seems I'm a bit late but this is the tool I made up to adjust the fingers through the inspection cover. My fingers were all too high like yours and they were all varied +/-1/16". The surface with the writing on it goes against the pressure plate and the finger contacts the pressure plate finger. I adjusted each so that a .002 feeler gauge would just drag. Smoothed my clutch right out. I would have made the part that goes against the pressure plate longer but that was the length that would fit through the inspection cover.
Attached Images
File Type: jpg IMG_8797.jpg (30.1 KB, 68 views)
File Type: jpg IMG_8798.jpg (31.3 KB, 66 views)
ryanheacox is offline   Reply With Quote