Thread: Light switch
View Single Post
Old 08-27-2019, 02:06 PM   #5
rotorwrench
Senior Member
 
rotorwrench's Avatar
 
Join Date: Jun 2010
Location: San Antonio, Texas
Posts: 11,924
Default Re: Light switch

The attachment of the rotating brass contactor ring and its insulator up in the upper body can be damaged due to improperly made parts. The lower contact plate is sometimes too thick and can lead to this type damage due to too much friction between parts.

A&L likely makes the best reproduction stuff but it all has to match up. Either 4-contact with OEM parts or 3-contact parts all have to match up. I think the 3-contact type is the only one reproduced. The old H type 4 contact would have to be good original stuff with all parts matching up on the design.
rotorwrench is offline   Reply With Quote