Quote:
Originally Posted by Talkwrench
That doesn't look right. Although it looks like you have 1/2" lines those fittings in the block dont look like 3/8 NPT ? I could be wrong.. You definitely have the grub screw in place between the two ports. Shorten those lines as much as possible, double check they're on the right way round [Ask Ron ; o ) ]. I can't see how you can pull over 60 lbs the relief should be doing its job, unless you have a blockage in the pipe....maybe??
|
Yes, they're 3/8 - Red's Headers Full Flow Kit. In on the filter is going to out on the block and vise a versa, assuming the machinist did it the way the directions said.